Difference between revisions of "7501T8"
From Sensoray Technical Wiki
(+826 notes) |
(→Using with model 826) |
||
| Line 70: | Line 70: | ||
==Using with model 826== | ==Using with model 826== | ||
| − | The relay rack can be connected to | + | The relay rack can be connected to header J3 or J2 on the 826 board. |
You must supply 5 VDC power to the relay rack. This can be done in either of the following ways: | You must supply 5 VDC power to the relay rack. This can be done in either of the following ways: | ||
* Connect an external 5 VDC power source to the relay rack's +5V and GND terminals. | * Connect an external 5 VDC power source to the relay rack's +5V and GND terminals. | ||
* Attach a wire on the bottom of the relay rack (via solder) from the +5V terminal to J1 pin 49. | * Attach a wire on the bottom of the relay rack (via solder) from the +5V terminal to J1 pin 49. | ||
Revision as of 15:14, 12 July 2018
Model 7501T8 is a solid-state relay (SSR) rack that accommodates up to eight G4 type SSR modules. It has a 50-pin header which is compatible with several Sensoray GPIO products, including models 826 and 2410.
Pinout
| SSR Module |
Header Pin |
Terminal Block Pins |
Model 826 J3 GPIO |
Model 826 J4 GPIO |
Model 2410 GPIO |
|---|---|---|---|---|---|
| 0 | 47 | 1-2 | 0 | 24 | 17 |
| 1 | 45 | 3-4 | 1 | 25 | 19 |
| 2 | 43 | 5-6 | 2 | 26 | 21 |
| 3 | 41 | 7-8 | 3 | 27 | 23 |
| 4 | 39 | 9-10 | 4 | 28 | 9 |
| 5 | 37 | 11-12 | 5 | 29 | 11 |
| 6 | 35 | 13-14 | 6 | 31 | 13 |
| 7 | 33 | 15-16 | 7 | 31 | 15 |
Using with model 826
The relay rack can be connected to header J3 or J2 on the 826 board.
You must supply 5 VDC power to the relay rack. This can be done in either of the following ways:
- Connect an external 5 VDC power source to the relay rack's +5V and GND terminals.
- Attach a wire on the bottom of the relay rack (via solder) from the +5V terminal to J1 pin 49.