826

From Sensoray Technical Wiki
Revision as of 17:18, 23 April 2013 by Admin (talk | contribs) (added cal error; recommend J6 install)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Calibration errors

On some SDKs, the analog calibration values will not be applied without J6 (labeled "Calibration Enable") installed. The shunt is intended to protect against accidental overwriting of the calibration values, but in these SDKs it also prevents the reading of those values. If board calibration is incorrect, make sure J6 is installed.

Retrieved from "https://www.sensoray.com/wiki/index.php?title=826&oldid=3"